End of Bearer 10mm Thick 14mm Bolt Holes-E

Make your build quicker and easier with an adjustable stump and make levelling a breeze! Even after installation these stumps only require a large shifter to adjust through a range of 120mm. 

The End of Bearer top is a standard flat plate, 140mm x 75mm. With a single hole, for bolting vertically into the bearer. This design is used at the end of a bearer located on the outside edge of the sub-floor.

• Hot Dipped Galvanised
• M30 x 200mm Thread
• 10mm Top Plate & 14mm Bolt Hole
• Suits all LevelMaster Connectors